[Q70-Q85] Updated Feb-2023 Test Engine to Practice Test for H12-811-ENU Exam Questions and Answers!

QUESTION 70
Using the command mkdir test in the VRP operating platform, the system will create a directory named test.

True

False

QUESTION 71
The load sharing mode at both ends of the Eth-Trunk can be inconsistent.

TRUE

FALSE

QUESTION 72
The subnet mask of a network segment 150.25.0.O is 255.255.224.0, then what is a valid host address in the network segment?

150.25.2.24

150.25.0.0

150.25.1.255

150.15.3.30

QUESTION 73
Which of the following description about the Layer 2 Ethernet switch is incorrect?

It is necessary to make certain modifications to the layer 3 header of the forwarded message, and then forward it

Able to learn MAC address

Forward according to the Layer 2 header information of the Ethernet frame

Layer 2 Ethernet switches work at the data link layer

QUESTION 74
The two switches shown in the figure below have both enabled the STP protocol. Which port will eventually be in the Blocking state?

G0/0/2 port of SWB

G0/0/3 port of SWB

G0/0/2 port of SWA

G0/0/3 port of SWA

QUESTION 75
As shown in the figure, the two switches use the default parameters to run STP, the configuration command STP root primary is used on switch A, and the configuration command STP priority 0 is used on switch B.
Then which port will be blocked?

G0/0/1 of switch B

G0/0/1 of switch A

HUB’s G0/0/3

G0/0/2 of switch A

QUESTION 76
The administrator plans to implement route backup by configuring static floating routes, what is the correct way to achieve this?

The administrator needs to configure different metric values for the main static route and the standby static route

The administrator needs to configure different TAGs for the main static route and the standby static route

The administrator only needs to configure two static routes

The administrator needs to configure different protocol priority values for the main static route and the standby static route

QUESTION 77
Which of the following SNMP packets are sent to the NMS by the Agent on the managed device?

Set-Request

Get-Request

Get-Next-Request

Response

QUESTION 78
Which state does the OSPF protocol use to indicate that the adjacency relationship has been established?

Full

2-way

Attempt

Down

QUESTION 79
What is the maximum negotiation rate supported by the IEEE 802.llg standard?

300Mbps

150Mbps

54Kbps

1200Mbps

QUESTION 80
VLAN 4095 cannot be created on Huawei switches, and VLAN 1 cannot be created.

TURE

FALSE

QUESTION 81
If the broadcast address of a network is 172.16.1.255, what might its network address be?

172.16.2.0

172.16.1.128

172.16.1.1

172.16.1.253

QUESTION 82
What are the roles of OSPF protocol DR and BDR? (Multiple choice)

Reduce the number of adjacencies

Reduce the types of OSPF protocol packets

Reduce the time to establish adjacency

Reduce the number of exchanges of link state information.

QUESTION 83
On Huawei routers, what is the default value of the OSPF protocol internal routing priority?

QUESTION 84
In the broadcast network as shown in the figure, OSPF runs on four routers in the same area and on the same network segment. OSPF will automatically elect one DR and multiple BDRs to achieve better backup results.