[Apr 22, 2022] Passing Key To Getting NS0-194 Certified Exam Engine PDF [Q44-Q61]

QUESTION 44
You received the “CLUSTER ERROR: DISK/SHELF COUNT MISMATCH” AutoSupport message from an ONTAP cluster.
When analyzing this message, which two should be inspected? (Choose two.)

QUESTION 45
Referring to the exhibit.

A customer receives “CLUSTER NETWORK DEGRADED” AutoSupport messages from this clustered Data ONTAP system. The customer suspects that something occurred physically to the nodes after they had a data center maintenance move.
The customer proceeds to follow the instructions in the Knowledge Base article regarding the “Error: CLUSTER NETWORK DEGRADED” message that results in the output shown In the exhibit.
After analysis, the customer decides to replace the small form-factor pluggable (SFP) transceivers and the cables on the system.
Which statistic supports the customer’s analysis?

QUESTION 46
After a recent unplanned power outage at the site, the power has been restored and you notice power supply fault messages in the event management system (EMS) log or fault lights on the storage shelves.
Which command would you use to collect information about the problem?

QUESTION 47
Which two statements describe ONTAP NVRAM? (Choose two.)

QUESTION 48
Your storage system has experienced a double-disk failure. When is this scenario considered to be in double-degraded mode?

QUESTION 49
Which three transport protocols are used to deliver AutoSupport data to NetApp? (Choose three.)

QUESTION 50
The details from within Active IQ Cluster Viewer are downloadable in which three file formats? (Choose three.)

QUESTION 51
Referring to the exhibit.

A customer contacts you and asks for assistance in determining which ports can be used for a new broadcast domain on a clustered Data ONTAP 8.3.2 system.
The system is serving LUNs using the FC protocol and is in production.
However, for Ethernet traffic, it is not yet in production. The customer provides you the output of the network port show command.
Referring to the exhibit, which ports will be eligible to create a new broadcast domain without impacting production storage virtual machines (SVMs) serving FC LUNs?

QUESTION 52
You want to monitor and generate reports on a customer’s IT infrastructure, including virtual and cloud-based components, even though the customer has not purchased or installed any ONTAP software.
In this scenario, which NetApp tool would be used to accomplish this task?

QUESTION 53
You are using FCP and iSCSI protocols from your clients with ONTAP as the target. You want to ensure that storage failover (SFO) works correctly for your clients.
In this scenario, which two features on the initiator and the target will accomplish this task? (Choose two.)

QUESTION 54
While troubleshooting intermittent takeover impossible command entries on the console, you request the output of the storage failover interconnect statistics error show command.
Which two counters would help troubleshoot this problem? (Choose two.)

QUESTION 55
A FAS system that is backed by 7200 RPM drives is experiencing extremely latent writes and slow but less latent reads.

Referring to the exhibit, what are two reasons for this result? (Choose two.)

QUESTION 56
A customer wants to protect the data in a volume using a schedule configured on a cluster. The customer is required to retain more backups on the destination than are present on the source.
What would the customer use to protect the data in this situation?

QUESTION 57
Your customer calls to report that he is seeing many cyclic redundancy check (CRC) errors on the FC-AL loop.
Which three commands would you use to determine the cause? (Choose three.)

QUESTION 58
A customer mentions that their Windows users cannot access clustered Data ONTAP 8.3.1 CIFS shares. The users see “access denied” on the Windows side.
Host name resolution is working and properly resolves IP to host name and host name to IP and the customer can ping using host name and IP. In this scenario, which statement describes the problem?

QUESTION 59
A customer receives the message shown below in their EMS logs.
Tue Jun 27 18:34:18 CEST
[netapp-ct1: cp_worker: wafl.cp.toolong:error]: Aggregate AG1_NTAP_PROD experienced a long CP.
Tue Jun 27 18:37:10 CEST
Which two data sources do you use to explain this message? (Choose two.)

QUESTION 60
As part of your backup policy, you configured a local snapshot schedule on your production volume. You review the list of Snapshot copies and you do not see a snapshot from last night.
What are two causes for this problem? (Choose two.)

QUESTION 61
A customer fails to see any disks in SnapDrive for Windows but they do see them in File Explorer. Which two statements describe what you should do to solve this problem? (Choose two.)