[May 29, 2022] NCM-MCI-5.15 Dumps Full Questions – Exam Study Guide [Q50-Q68]

Q50. Microsegmentation was recently enabled in a Nutanix environment. The administrator wants to leverage Prism Central to create a policy that will block all traffic, regardless of direction, between two groups of VMs identified by their category.
Which policy should be used to meet this requirement?

Q51. An administrator is planning to deploy a Nutanix cluster to support a few high-performance VMs. This deployment will have the following considerations:
* Individual VMs will likely generate network throughputs in the range of 90-100Mbps
* Due to the configuration of the VMs, it is unlikely that a node will host more than one or two of them at a time
* Individual VMs will communicate with only a few (one or two) remote hosts at a time
* Multicast will not be used in the environment
* The hosts are connected via two 1GbE network connections
How should the administrator configure the network bonds to meet this requirement while maintaining the simplest switch configuration?

Q52. An administrator configures authentication in Prism Central (PC) for the NTNX-Admins group. Users report that they are unable to log in. The administrator confirms that the Active Directory (AD) settings in PC are correct.
Which condition could result in this behavior?

Q53. After the migration, some SQL queries take longer to execute than prior to migration.
The following SQL best practices were applied while creating the SQL VM on Nutanix:
*8 vDisks per SQL server VM
*Database and Log files on separate vDisk
*2 TempDB database drives and 1 TempDB log drive
What should the administrator to do improve the SQL Server performance?

Q54. Refer to the exhibit.

An administrator logs in to Prism and sees the status shown in the exhibit within the Hardware Diagram section.
What should the administrator do?

Q55. An administrator is notified that a bare metal database server is down. This database server is being served storage using a Nutanix Volume Group. Upon investigating, the administrator finds that the disks in the database server that map to the vDisks in the volume group have gone offline.
What is causing this issue?

Q56. An administrator protected a DB VM running on a Nutanix cluster with NearSync Replication, which schedules to repeat every 15 minutes to a second site. The daily change rate is low. During nightly backups, the replication window is missed due to write volume.
Which two options describe the expected behavior? (Choose two.)

Q57. An administrator is implementing a VDI solution. The workload will be a series of persistent desktops in a dedicated storage container within a four-node cluster. Storage optimizations should be set on the dedicated storage container to give optimal performance including during a node failure event.
Which storage optimizations should the administrator set to meet the requirements?

Q58. An administrator is managing multiple Windows and Linux VMs connected to Nutanix Volumes. The Linux VMs are experiencing intermittent connectivity issues. The Windows VMs do not experience the same issue.
Which option should the administrator use to resolve this issue?

Q59. An organizations Nutanix Cluster is based on VMware vSphere. The cluster is configured to download software updates automatically. The administration needs to verify and eventually upgrade VMware hypervisor via Prism Ul.
After logging in to Prism, the administrator receives the message shown:
No available versions for upgrade
What is causing the current state?

Q60. An administrator finds that home shares cannot be configured in a new Files 3.5 deployment. Why is this happening?

Q61. Refer to the exhibit.

What is the purpose of eth2 on the CVMs?

Q62. An administrator is monitoring the Nutanix v5.15-based AOS cluster performance logs and notices that a SQL server VM is greatly exceeding its intended maximum IOPS. The administrator has confirmed that a QoS policy was previously created for the group of VMs this server is a member of.
What are two reasons that this VM would exceed its maximum configured IOPS from the QoS Policy?
(Choose two.)

Q63. An administrator manages the following two Nutanix AOS 5.15 cluster environment:
* Corp-cluster-01
* Corp-cluster-02
The VM images must be available only on Corp-cluster-01, but cannot be checked out to cluster Corp-cluster-02. The images also cannot be checked out to any other clusters that are registered with Prism Central in the future.
Which two configuration settings must the administrator choose when creating the image placement policy that satisfies the stated requirements? (Choose two.)

Q64. A customer has NearSync configured. When the administrator tries to restore a snapshot from 3 minutes ago, it is not available. The snapshots are happening at 15-minute intervals instead of at the 5-minute configured interval. When the protection domain was initially set up, the snapshots were happening at the expected
5-minute interval.
What should the customer do to enable the snapshots to happen at the expected interval?

Q65. A Nutanix cluster is deployed with the following configuration:
* Three four-node blocks (A, B, and C)
* All Flash Redundancy Factor 2
What is the effect of simultaneous disk failures on two nodes located in block A?

Q66. An administrator needs to make sure an RF3 cluster can survive a failure of two complete racks without negatively affecting performance. The current cluster configuration consists of the following:
* 30 All Flash Nodes: distributed 10 nodes per rack across three 42U racks
* Each node is configured with 20TB usable storage all flash (Cluster Total 600TB Usable)
* Current cluster utilization is 500TB storage
* Storage containers have Erasure Coding enabled
Which configuration changes should be made to make sure the cluster meets the requirements?

Q67. An alert about RX errors on eth2 on a node is reported in the cluster. The administrator logs in to the CVM in question, checks the ping_* files in the data/logs/syststats folder, and notices intermittent ping loss.
The node in question has the following network configuration:

Which action should be used to troubleshoot without disrupting the VMs running on this node?

Q68. An administrator is configuring an All Flash cluster to support the following workloads:
* Full clone virtual desktops
* Hadoop
* Write heavy databases
Which three correct configuration options should the administrator use to meet the item requirements?
(Choose three.)
For each procedure, indicate whether it is a correct or incorrect procedure that must be configured to meet the item requirements using the drop-down option.