[Jun 28, 2022] NSE6_FML-6.2 Dumps Full Questions – Exam Study Guide [Q18-Q42]

QUESTION 18
Refer to the exhibit.

Which two statements about the access receive rule are true? (Choose two.)

QUESTION 19
Examine the FortiMail user webmail interface shown in the exhibit; then answer the question below.

Which one of the following statements is true regarding this server mode FortiMail’s configuration?

QUESTION 20
Which two CLI commands, if executed, will erase all data on the log disk partition? (Choose two.)

QUESTION 21
Examine the FortiMail IBE users shown in the exhibit; then answer the question below

Which one of the following statements describes the Pre-registered status of the IBE user [email protected]?

QUESTION 22
Examine the message column of a log cross search result of an inbound email shown in the exhibit; then answer the question below

Based on logs, which of the following statements are true? (Choose two.)

QUESTION 23
Examine the FortMail mail server settings shown in the exhibit; then answer the question below.

Which of the following statements are true? (Choose two.)

QUESTION 24
What are the configuration steps to enable DKIM signing for outbound messages on FortiMail? (Choose three.)

QUESTION 25
Refer to the exhibit.

An administrator has enabled the sender reputation feature in the Example_Session profile on FML-1. After a few hours, the deferred queue on the mail server starts filling up with undeliverable email. What two changes must the administrator make to fix this issue? (Choose two.)

QUESTION 26
Examine the configured routes shown in the exhibit; then answer the question below.

Which interface will FortiMail use to forward an email message destined for 10.1.100.252?

QUESTION 27
Refer to the exhibit.

An administrator must enforce authentication on FML-1 for all outbound email from the example.com domain. Which two settings should be used to configure the access receive rule? (Choose two.)

QUESTION 28
Examine the FortiMail session profile and protected domain configuration shown in the exhibit; then answer the question below.


Which size limit will FortiMail apply to outbound email?

QUESTION 29
Examine the FortiMail active-passive cluster shown in the exhibit; then answer the question below.


Which of the following parameters are recommended for the Primary FortiMail’s HA interface configuration?
(Choose three.)

QUESTION 30
What three configuration steps are required to enable DKIM signing for outbound messages on FortiMail?
(Choose three.)

QUESTION 31
Which three statements about SMTPS and SMTP over TLS are true? (Choose three.)

QUESTION 32
Refer to the exhibit.

Which configuration change must you make to block an offending IP address temporarily?

QUESTION 33
Refer to the exhibit.

Which statement describes the impact of setting the User inactivity expiry time option to 90 days?

QUESTION 34
Refer to the exhibit.

Which statement describes the impact of setting the User inactivity expiry time option to 90 days?

QUESTION 35
A FortiMail administrator is investigating a sudden increase in DSNs being delivered to the protected domain for undeliverable email messages. After searching the logs, the administrator identifies that the DSNs were not generated as a result of any outbound email sent from the protected domain.
Which FortiMail antispam technique can the administrator use to prevent this scenario?

QUESTION 36
Refer to the exhibit.

Which message size limit will FortiMail apply to the outbound email?

QUESTION 37
Examine the FortiMail topology and IP-based policy shown in the exhibit; then answer the question below.

An administrator has enabled the sender reputation feature in the Example_Session profile on FML-1. After a few hours, the deferred queue on the Mail Server started filing up with undeliverable email. What changes should the administrator make to fix this issue? (Choose two.)

QUESTION 38
Refer to the exhibit.

Which configuration change must you make to block an offending IP address temporarily?

QUESTION 39
While testing outbound MTA functionality, an administrator discovers that all outbound email is being processed using policy IDs 1:2:0.
Which two reasons explain why the last policy ID value is 0? (Choose two.)

QUESTION 40
Refer to the exhibit.

It is recommended that you configure which three access receive settings to allow outbound email from the example.comdomain on FML-1? (Choose three.)

QUESTION 41
Refer to the exhibit.

Which two statements about the access receive rule are true? (Choose two.)

QUESTION 42
Refer to the exhibit.

What are two expected outcomes if FortiMail applies this antivirus action profile to an email? (Choose two.)