[Jul-2022] H35-211_V2.5 Pre-Exam Practice Tests Exam Questions and Answers for HCIP-Access Study Guide [Q31-Q53]

NO.31 OLT can support direct replication of user packet priority as the priority of forwarding packets, and also
supports direct local configuration

NO.32 (Multiple select) When there is a backbone fiber break or OLT does not detect the expected optical signal
(L0S) alarm, the possible cause is that

NO.33 The auto-discovery methods provided by sight are by network segment mode, ARP mode and routing mode.
At the same time, you can create a network segment or IP address of a device that does not need to be
connected as an exclusion list. Automatically skips the network segment or IP address configured in the
exclusion list during self-discovery of devices.

NO.34 (Multi-select) Use 0TDR to locate the abnormally attenuated location in the optical path, and after the OTDR
is connected to the detected line, which of the following parameters can be set.

NO.35 The (radio) 10G GPON system uses XGEN frames to encapsulate data, and the PORT ID is defined in the
XGEN header as () bits.

NO.36 When ont fails or the hardware needs to be replaced, the ONT service needs to be replaced, and then the ONT
service needs to be removed on the OLT, and then the new ONT service needs to be registered

NO.37 OLT can perform traffic shaping through service-port.

NO.38 In the evolution of EPON to 10g EPON, a smooth transition is achieved at the local end by adding AWDM
WDM module, and Odn coexists.

NO.39 (Radio) In the ACL, if you need to filter the packet according to the source IP address information, destination
IP address information, port number and other information of the packet, then the acl number template created
is

NO.40 Layer 2 enables IGMP-snooping , and when the switch port receives an IGMP join packet, it listens for the
packet and adds the corresponding port to the multicast group

NO.41 (Radio) Regarding multicast, the following description is incorrect

NO.42 Multicast technology effectively solves the problem of single-point transmission and multipoint reception, and
realizes efficient data transmission from midpoint to multipoint in IP network.

NO.43 The number of users under the OLT can also determine whether the VLA is single-layer or dual-layer VLA.
Single-layer VLANs can be used when the number of users is small, and dual-layer VLANs must be used
when the need to distinguish services and the number of users is second to ().

NO.44 (Single choice) The following statement about the PITP protocol is incorrect

NO.45 (Single-choice) An IPTV user reflects that the TV cannot be watched, open the debug switch on the OLT side,
and the debug printing information is as follows: huawei( config).
This can be judged by the results of the query

NO.46 (Radio) The downstream effective bandwidth of the GPON PON port is

NO.47 The establishment, maintenance and dismantling of the word path between the SIP user and the server are
done through the interaction of the –series of messages, so that every information contained in the SIP text has
a –nature, There is no phenomenon in which a single information value appears multiple times.

NO.48 (Single choice) The following statement about defense MAC Spoofing is wrong

NO.49 Under IGMP snooping, there are two users on demand under the OLT- the same program, and the olt sends
two join messages to the multicast router

NO.50 The (radio) OLT is configured for V2 on the IGMP version when the OLT receives igmr v3 forwarded from
on-T What kind of treatment will be done after joining the message

NO.51 (Multi-select) Network Management U2000 adds line templates to realize the mapping of user traffic flows to
GEM PORTS, including mapping modes(Radio)

NO.52 (Multi-select) VLAN planning principles need to be considered

NO.53 (Radio) When configuring multicast services on MA5600T/MA5680T, the programs of multicast VLANs are
statically configured, and which of the following options must be configured, otherwise the multicast
programs may not be able to be watched