Authentic CTFL_001 Dumps – Free PDF Questions to Pass [Q117-Q140]

5/5 - (1 vote)

Authentic CTFL_001 Dumps – Free PDF Questions to Pass

Guaranteed Accomplishment with Newest Jul-2022 FREE CTFL_001

NEW QUESTION 117
Which of the following activities is appropriate to the test planning stage?

Analyzing the test basis

Assigning resources for the planned activities

Designing the test environments

Writing a test execution schedule

NEW QUESTION 118
A test assessment has been carried out using the selected model as a reference framework. A number of recommendations have been identified and you are asked to prioritize them. Based on your knowledge of the project, you are expecting severe resistance to change. Which of the following would be the most important selection criterion for defining the priority of the recommendations? 2 credits

Synchronized with the overall long-term organizational strategy

Defined according to the maturity model used

Most visible to stakeholders

Low costs actions first

NEW QUESTION 119
Which of the following are aids to good communication, and which hinder it?
i. Try to understand how the other person feels.
ii. Communicate personal feelings, concentrating upon individuals.
iii. Confirm the other person has understood what you have said and vice versa.
iv.
Emphasize the common goal of better quality.
v.Each discussion is a battle to be won.

(i), (ii) and (iii) aid, (iv) and (v) hinder.

(iii), (iv) and (v) aid, (i) and (ii) hinder.

(i), (iii) and (iv) aid, (ii) and (v) hinder.

(ii), (iii) and (iv) aid, (i) and (v) hinder.

NEW QUESTION 120
Given the following figures for the testing on a project, and assuming the failure rate for initial tests remains constant and that all retests pass, what number of tests remain to be run?

700

720

784

570

NEW QUESTION 121
In general, why is it NOT a good idea to estimate the testing effort based only on a percentage of development effort? Identify THREE valid reasons. 1 credit

The quality of the development estimate may be poor.

In general bottom-up estimation is always better than top-down estimation.

The percentage based technique only applies to the V life cycle model.

Using the same percentage every time does not address the level of risk of the application to be tested.

The maturity of the organization, e.g. the quality of the test basis, quality of development testing, configuration management, availability of test tools, also influence the effort needed for testing.

It builds on large set of historical data

The result is almost always a too low estimate for the required test effort

NEW QUESTION 122
Consider the typical objectives of testing. Which of the following metrics can be used to measure the effectiveness of the testing process in achieving one of those objectives?

Average number of days between defect discovery and resolution

Percentage of requirements covered

Lines of code written per developer per day

Percentage of test effort spent on regression testing

NEW QUESTION 123
Which of the following principles should be followed when introducing a test tool into an organization?
(i) Assessing organizational maturity to establish whether a tool will provide expected benefits.
(ii) Requiring a quick payback on the initial investment.
(iii) Including a requirement for the tool to be easy to use without having to train unskilled testers.
(iv) Identifying and agreeing requirements before evaluating test tools.

(i) and (ii)

(i) and (iv)

(ii) and (iii)

(iii) and (iv)

NEW QUESTION 124
Independent Verification & Validation is:

Done by the Developer

Done by the Test Engineers

Done By Management

Done by an Entity Outside the Project’s sphere of influence

NEW QUESTION 125
A test log is one of the documents that need to be produced in this domain in order to provide evidence of testing.
However, the level of detail of test logs can vary. Which of the following is NOT an influencing factor for the level of detail of the test logs being produced? 1 credit

Level of test execution automation

Test level

Regulatory requirements

Experience level of testers

NEW QUESTION 126
Which of the following phases in the fundamental test process is considered to deliver a document which can be used as a major input for test process improvement? 1 credit

Test planning and control

Test implementation & execution

Evaluating exit criteria and reporting

Test project closure

NEW QUESTION 127
Which of the following statements is the MOST valid goal for a test team?

Determine whether enough component testing was executed.

Cause as many failures as possible so that faults can be identified and corrected.

Prove that all faults are identified.

Prove that any remaining faults will not cause any failures.

NEW QUESTION 128
What other details should be included in the following incident report when it is first submitted?
Date of Issue: 23/11/05
Severity: P1
Build: Version15.6
Details: Expected field to be limited to 15 chars, able to enter 27

Suggested solution, priority and number of defects assigned to this developer.

Status of the incident, degree of impact, Test Case Number.

History, related defects and expected fix time.

Line of code, number of defects found, time of day.

NEW QUESTION 129
Model characteristics:
Which THREE of the below mentioned characteristics relate to TMMi? 1 credit

5 maturity levels

Focussed on higher level testing

20 key areas

Highly related to CMMI

Continuous model

Staged model

Focussed on component and integration testing

Is build around 12 critical testing processes

NEW QUESTION 130
An iPhone application identifies and counts all purchases of a particular product from a shopping website. The application incorrectly counts purchase attempts by including both failed attempts, and also those where the purchase was terminated by the user before completion. Testing has identified that the problem was located in the ‘purchase identification’ module, where the first stage in the purchasing process was counted, rather than a successful confirmed purchase.
Which of the following statements correctly identifies what has happened? [K2]

The application failed because of a defect in the purchase identification module caused by a programmer mistake or an error in the specification.

An error by the programmer led to a mistake in the purchase identification module and this caused a defect in the application

A defect in the purchase identification module caused by a mistake in the module specification led to a defect in the overall application

A bug in the purchase identification module caused a fault in the application

NEW QUESTION 131
Testers are often seen as the bearer of unwanted news regarding defects. What are effective ways to improve the communication and relationship between testers and others?
a) Communicate factual information in a constructive way.
b) Try to understand how the other person feels and why they react the way they do.
c) Always outsource testing activities.
d) Never record information that could be used to apportion blame to an individual or team.

a and b

a, b and c

a, b and d

a and c

NEW QUESTION 132
Which of the following defines the expected result of a test?

Test case

Test procedure

Test execution schedule

Test condition

NEW QUESTION 133
Which of the following statements describes a key principle of software testing?

Automated tests allow better statements of confidence about the quality of software products.

For a software system, it is normally impossible to test all the input and output combinations.

Exhaustive software testing is, with enough effort and tool support, feasible for all software.

The purpose of software testing is demonstrating the absence of defects in software products.

NEW QUESTION 134
Which of the following is an example of testing as part of the requirements specification phase?

A requirements review meeting

A business analyst eliciting requirements

Performing acceptance tests against requirements

A test report showing requirements coverage

NEW QUESTION 135
Consider the typical objectives of testing. Which of the following metrics can be used to measure the effectiveness of the testing process in achieving one of those objectives? 1 credit

Average number of days between defect discovery and resolution

Percentage of requirements covered

Lines of code written per developer per day

Percentage of test effort spent on regression testing

NEW QUESTION 136
As part of the test strategy, entry and exit criteria will be defined for each test level. Which is NOT a valid reason for using entry and exit criteria? 1 credit

The expectation is that development testing is not adequate.

Exit criteria are used to decide on when to stop testing.

Entry and exit criteria are a principal way for getting adequate resources.

Using entry and exit criteria will prevent software that is not or poorly tested from going to the next test level.

NEW QUESTION 137
In general, why is it NOT a good idea to estimate the testing effort based only on a percentage of development effort? Identify THREE valid reasons. 1 credit

The quality of the development estimate may be poor.

In general bottom-up estimation is always better than top-down estimation.

The percentage based technique only applies to the V life cycle model.

Using the same percentage every time does not address the level of risk of the application to be tested.

It builds on large set of historical data

The result is almost always a too low estimate for the required test effort

NEW QUESTION 138
Hand over of Testware is a part of which Phase:

Test Analysis and Design

Test Planning and control

Test Closure Activities

Evaluating exit criteria and reporting

NEW QUESTION 139
Which of the following is MOST important in the selection of a test approach?

Availability of tools to support the proposed techniques.

The budget allowed for training in proposed techniques.

Available skills and experience in the proposed techniques.

The willingness of the test team to learn new techniques.

NEW QUESTION 140
Which of the following would be the TWO most appropriate examples of entry criteria documented in the system integration test plan?

The percentage of decision coverage achieved during unit testing.

The availability of the latest version of the capture-replay tool (for testing the interface with the newly developed test management tool).

The sign-off of a performance test software release note (test item transmittal report) by both development and testing showing that system performance meets the specified acceptance criteria.

The percentage of acceptance test procedures scheduled for execution.

The percentage of requirements coverage achieved during system integration test.

ISQI CTFL_001 Exam Syllabus Topics:

Topic	Details
Topic 1	Planning and specification to the conducting and monitoring of tests
Topic 2	Who wants a basic understanding of software testing such as project managers
Topic 3	Certificate will be able to go on to a higher level software testing qualifycation