[Mar 14, 2023] Genuine NS0-516 Exam Dumps New 2023 Network Appliance Pratice Exam [Q17-Q40]

NO.17 Which type of caching on E-Series systems should be enabled according to NetApp recommended practices?

NO.18 Click the Exhibit button.

A customer’s host is running a Red Hat Enterprise Linux 7.6 server with dm-mp configured for ALUA and is connected to a single volume on the EF280 system that is shown in the exhibit.
In this scenario, how many active/optimized paths are available to the volume?

NO.19 Which command on a NetApp storage controller will display the average service time on a FC target port basis every five seconds?

NO.20 An administrator is asked to provision a 1 TB volume to hold non-critical temporary data for a seismic-analysis application. The volume requires the highest possible IOPS.
In this scenario, which configuration would satisfy this requirement?

NO.21 Which object provides read/write access to a Snapshot image?

NO.22 Your company has deployed an E2824 and has decided to change the host protocol from iSCSI to FC You use the storage array profile to review the installed SFPs.
In this scenario, which set of supported data rates indicates that you are using dual-purpose SFPs?

NO.23 What SANtricity package(s) must be installed on a Windows server when it is acting as both a data host and a storage management host?

NO.24 Exhibit:

Referring to the exhibit, what would you select in the search list to see all of the host selections for NetApp ESeries storage systems?

NO.25 If you want to mirror data from Los Angeles to New York (approximately a 5,000-km distance), which mirroring feature should you use?

NO.26 Click the Exhibit button.

Referring to the exhibit, which cable is an InfiniBand 4X connector?

NO.27 Identify this image.

NO.28 Which two steps are required to enable multifactor authentication on an E-Series system? (Choose two.)

NO.29 What does a lit blue SAA LED indicate?

NO.30 During normal operation, a failure was detected on an E-Series hardware component.
Which tool could be used to determine the location of the failed component and understand the potential recovery actions? (Choose the best answer.)

NO.31 Which three documents should be provided to the customer after the E-Series installation is complete?
(Choose three.)

NO.32 What is SMutil? (Choose the best answer.)

NO.33 Your company has an E-Series system connected to Cisco MDS switches. You are asked to provision a volume on a new Windows host, but the Windows host is unable to connect to the volume on the E-Series system. All other Windows hosts in the fabric are able to connect to their volumes.
In this scenario, which three actions should you perform to accomplish this task? (Choose three.)

NO.34 When replacing failed disks, what is a consideration for replacement disks?

NO.35 Click the Exhibit button.

A customer has a raised floor with a weight limit of 700 lb. per floor tile. The customer’s data cabinet weights
90 lb. and covers a single floor tile.
Referring to the exhibit, what is the maximum number of E2824 shelves possible to be installed?

NO.36 The decision to use FC or iSCSI on the 5500 Controller with a 4-port 16Gb/s FC or 10Gb/s iSCSI Optical SFP+ HIC (Host Interface Card) can be ___________. (Choose the best answer.)

NO.37 You are adding drives to an existing Dynamic Disk Pool (DDP). In this scenario, which two drive characteristics should you consider when selecting the drives? (Choose two.)

NO.38 A NetApp recommended best practice is to cable disk shelves to a controller shelf using the top-down-bottom-up method.
Why?

NO.39 Which two errors would fail a pre-upgrade health check? (choose two.)

NO.40 You help a customer diagnose a performance issue on an E-Series storage system. You decide to measure the amount of data that is being handled over the span of an hour.
In this scenario, what are you measuring?