H35-460-ENU Practice Exam and Study Guides – Verified By Real4exams Updated 221 Questions [Q67-Q91]

QUESTION 67
The bandwidth of PRACH in NR is fixed.

QUESTION 68
If the main control board UMPT uses a 10Gbps optical module when the NR base station is turned on, the ETHPORT of GTRANSPARA must be configured to 10Gbps and cannot be configured to slow down.

QUESTION 69
gNodeB binds the carrier ID when adding tracking area information.

QUESTION 70
In the NSA Networking Option3x series scenario, gNodeB must configure an X2 interface.

QUESTION 71
What is IMT-2020’s vision for peak rates for 5G networks?

QUESTION 72
Under the EN-DC architecture, the eNodeB/gNodeB only supports the configuration of the X2 finger based on the EndPoint method.

QUESTION 73
In the NSA networking scenario, gNodeB does not need to configure the X2 interface.

QUESTION 74
Which description is wrong about the twist line test on the U2000?

QUESTION 75
When NSA selects and interprets the 2.6Ghz band networking, the uplink and downlink decoupling scheme can not be used.

QUESTION 76
The VLNA group mode of gNodeB can tag different service flows with VLAN tags based on the service type.

QUESTION 77
What is the MML command used by gNodeB to add CI port configuration?

QUESTION 78
gNodeB supports two VLAN modes: single VLAN mode and VLAN group mode.

QUESTION 79
Which of the following does not belong to the BBU board?

QUESTION 80
In the NSA networking option3x scenario, which MOs in the S1 interface self-creation configuration of gNodeB are not needed and must be configured?

QUESTION 81
NR is divided into competitive and non-competitive random access, what is the main purpose of UE triggering random access?

QUESTION 82
After the 5G network UE is powered on and enters the idle state, what operations will be performed in the Attach process? (Multiple choice)

QUESTION 83
The fan modules of the BBU3910 and BBU5900 are compatible.

QUESTION 84
NSA network Option3x scenario, gNodeB in the S1 interface self-establishment configuration, which MOs are not required to be configured? (Multiple choice)

QUESTION 85
Which of the following MML commands do you need to perform to add neighbor information across the gNodeB? (Multiple choice)

QUESTION 86
In the 5G network test, what is the test distance between the CPE and the gNB on the terminal side?

QUESTION 87
Which of the following MML commands supports unblocking gNodeB cells?

QUESTION 88
What is the maximum bandwidth in the millimeter wave defined in the 3GPP R16 protocol?

QUESTION 89
Add gNodeB identity Which of the following MML commands is used?

QUESTION 90
​​In the scenario of the Option 3 series of the NSA network, the gNodeB needs to be configured with the S1-C interface.

QUESTION 91
Which application scenario of 5G is not described in 3GPP Release 15?