[Q144-Q160] Huawei H35-260 Practice Verified Answers – Pass Your Exams For Sure! [2023]

QUESTION 144
In the WDM transmission system, the main factors that affect the unevenness of the power balance of each channel do not include the following?

QUESTION 145
What is wrong with the statement that PTN LTE carries static L3VPN?

QUESTION 146
The thickness of the fiber core, the refractive index of the village material and the cladding material have a decisive influence on the characteristics of the fiber.

QUESTION 147
The device IP addresses of gateway network elements and non-gateway network elements must be set in the same network segment

QUESTION 148
Which of the following ways does the Inspector inspection tool support adding network elements?

QUESTION 149
1+1 protection means that when the sender sends service flows to both working and protected tunnels at the same time, the receiver selectively receives service flows according to the tunnel status or external commands.

QUESTION 150
During the debugging of the SDH system, if the E1 port reports a T-ALOS alarm, which of the following actions are meaningful?

QUESTION 151
Which of the following are the basic requirements of the DWDM system for the light source?

QUESTION 152
Which of the following paths can be configured on the network management?

QUESTION 153
The working mode of the port determines the flow control mode of the port. Which of the following flow control modes can be used when the operating mode is 100 Mbit/s full duplex

QUESTION 154
Which of the following Ethernet port alarms is not a physical layer alarm, that is, LSR_NO_HTED has no correlation with it, and there is no suppression relationship?

QUESTION 155
To create a unicast BFD session between two IP addresses in a PIN network, which of the following must be satisfied?

QUESTION 156
When configuring LMSP, there are two switching modes: single turbulent cutting and inserting and double full switching. Single-ended switching does not require self-use protection

QUESTION 157
The U2000 network management supports a variety of external interfaces. Which of the following interfaces can be used when connecting with the network management equipment of other manufacturers?

QUESTION 158
Which of the following conditions can cause the board to insert the BDI maintenance signal back to the upstream site?

QUESTION 159
Which item is wrong about the description of PTN network MC-PWAPS protection features?

QUESTION 160
When deploying LAG, which of the following can the traffic load sharing hash algorithm be based on?