NACE-CIP2-001 Dumps with Practice Exam Questions Answers [Q35-Q51]

Rate this post

NACE-CIP2-001 Dumps with Practice Exam Questions Answers

NACE-CIP2-001 by CIP Level 2 Actual Free Exam Practice Test

Q35. As a NACE Level 2 Inspector, NACE clearly indicates that you ate qualified to independently produce final documentation for a shop project.

True

False

Q36. The Concrete Repair Institute’s comparators can be used to assess:

Surface cleanliness prior to coating

Surface profile prior to coating

Contamination levels prior to coating

Compressive and tensile strength prior to coating

Q37. NACE International Standards are developed by:

Government mandates

International mandates

Standard committees

Regional mandates

Q38. The coating applicator has ignored a enface preparation hold point and applied coating over the surface without a sign off from you as the inspector.
Your FIRST preferred course of action is to:

Stop the job

Require the Applicator to remove the coating

Advise the Owner and write a Non-Conformance report

Ignore the situation

Q39. Which type of pipelines collect the gas from the transmission system so utility companies can distribute the gas to end users?

Gathering

Midstream

Transmission

Distribution

Q40. Coating Surveys are legally required:

On commercial marine vessels and offshore platforms

On high pressure gas lines and fireproofed structures

On water tanks and potable water pipelines

On food and beverage vessels and can linings

Q41. NACE No.13/ SSPC 6 identifies the use of:

Abrasive blasting only

Watterjetting only

Steam cleaning only

Various methods of cleaning

Q42. The cost of qualified Coating Inspection is normally offset by:

Lower Application Costs

Lower Coating Life Cycle Costs

Lower Safety Enforcement Costs

Lower Supervision Costs

Q43. From a corrosion perspective, the main difference between Ferrous and Non-Ferrous Metals is:

Cost

Iron content

Appearance

Safety

Q44. You are the NACE Coating Inspector on a tank lining project and are asked to perform a high voltage holiday test after the coating applicators have completed their final repairs. After meeting all the confined space entry permit you enter the tank and notice a very strong odor of solvent.
Your first course of action should to:

Investigate to find the source of the odor

Don your air supplied respirator and continue the testing

Exit the tank and immediately and report the problem to the nearest safety supervisor

Exit the tank and document the incident in your daily report

Q45. Corrosion is the reverse process of

hot dipping.

steel manufacturing.

flaking.

galvanic deterioration.

Q46. Inspection and Test plans are developed by referencing:

The Specification, TDS, relevant Standards and Codes

The Specification, SDS, relevant Standards and Codes

The Specification, Application Guidelines, ‘Relevant Standards and Codes

The Specification, Safety Manual, Relevant Standards and Codes

Q47. You are the NACY Coating Inspector on a tank lining project where desiccant dehumidification is being used. Since the first shift of abrasive blasting your readings have indicated relative humidity below 40%; however on the second shift of coating application your readings are indicting 80%.
Your FIRST preferred course of action is to:

Check to See if the dehumidification equipment is operating correctly

Call your supervisor

Advise the coating applicator supervisor of your readings

Document the readings at the end of the shift

Q48. Which product, when closely inspected has a green or red layer of fusion bonded epoxy (FBE) that is visible directly on the steel?

2-Layer Polyethylene (PE)

3-Layer Polyethylene (PE)

Fusion Bonded Epoxy

Coal Tar Enamel

Q49. Dehumidification is defined as the removal of moisture vapor from the air to

provide worker comfort.

lower its temperature