Free Feb-2026 UPDATED Fortinet FCSS_SDW_AR-7.4 Certification Exam Dumps is Online [Q32-Q47]

4/5 - (1 vote)

Free Feb-2026 UPDATED Fortinet FCSS_SDW_AR-7.4 Certification Exam Dumps is Online

Fortinet Exam 2026 FCSS_SDW_AR-7.4 Dumps Updated Questions

Fortinet FCSS_SDW_AR-7.4 Exam Syllabus Topics:

Topic	Details
Topic 1	Configure Performances SLAs: Designed for network administrators, this part focuses on setting up performance Service Level Agreements (SLAs) within SD-WAN environments. Candidates must show proficiency in defining criteria to monitor and maintain network performance and reliability.
Topic 2	SD-WAN Configuration: This section of the exam measures the skills of network engineers and covers configuring a basic SD-WAN setup. Candidates are expected to demonstrate their ability to define SD-WAN members and zones effectively, ensuring foundational network segmentation and management.
Topic 3	Centralized Management: This domain evaluates network administrators’ competence in deploying and managing SD-WAN configurations centrally using FortiManager. It includes tasks such as implementing branch configurations and utilizing overlay templates to streamline network management.

NEW QUESTION 32
The FortiGate devices are managed by ForliManager, and are configured for direct internet access (DIA). You confirm that DIA is working as expected for each branch, and check the SD-WAN zone configuration and firewall policies shown in the exhibits.

Then, you use the SD-WAN overlay template to configure the IPsec overlay tunnels. You create the associated SD-WAN rules to connect existing branches to the company hub device and apply the changes on the branches.
After those changes, users complain that they lost internet access. DIA is no longer working.
Based on the exhibit, which statement best describes the possible root cause of this issue?

The SD-WAN overlay template defines a zone for each underlay interface and moves the interfaces into those zones.

The SD-WAN overlay template didn’t configure a firewall policy to allow traffic through the overlay.

The SD-WAN overlay template redefines the interface gateway addresses if they are defined with metadata variables.

The SD-WAN overlay template updates the SD-WAN template and the rules.

NEW QUESTION 33
Refer to the exhibits.

An administrator is testing application steering in SD-WAN. Before generating test traffic, the administrator collected the information shown in the first exhibit. After generating GoToMeeting test traffic, the administrator examined the corresponding traffic log on FortiAnalyzer, which is shown in the second exhibit.
The administrator noticed that the traffic matched the implicit SD-WAN rule, but they expected the traffic to match rule ID 1.
Which two reasons explain why some log messages show that the traffic matched the implicit SD-WAN rule?
(Choose two.)

Full SSL inspection is not enabled on the matching firewall policy.

The session 3-tuple did not match any of the existing entries in the ISDB application cache.

FortiGate could not refresh the routing information on the session after the application was detected.

No configured SD-WAN rule matches the traffic related to the collaboration application GoToMeeting

NEW QUESTION 34
Refer to the exhibit.

An administrator checks the status of an SD-WAN topology using the FortiManager SD-WAN monitor menus. All members are configured with one or two SLAs.
Which two conclusions can you draw from the output shown? (Choose two.)

The template view should be used to see the hub devices.

One member of branch2_fgt is missing the SLAs.

branch2_fgt establishes six tunnels to the hubs and they are all up.

This SD-WAN topology contains only two branch devices.

NEW QUESTION 35
Refer to the exhibit that shows an SD-WAN zone configuration on the FortiManager GUI.

Based on the exhibit, how will the FortiGate device behave after it receives this configuration?

The configuration instructs FortiGate to choose an ADVPN shortcut based on SD-WAN information.

The configuration instructs FortiGate to allow ADVPN shortcuts for the tunnels of this SD-WAN zone.

The configuration instructs FortiGate to establish shortcuts only when at least two members meet the SLA target.

The configuration instructs FortiGate to establish shortcuts only for overlay interfaces that meet the SLA target HUB1_HC.

NEW QUESTION 36
In which SD-WAN template field can you use a metadata variable?

You can use metadata variables only to define interface members and the gateway IP.

Any field identified with a dollar sign (S) in a magnifying glass.

Any field identified with an “M” in a circle.

All SD-WAN template fields support metadata variables.

NEW QUESTION 37
Refer to the exhibit that shows event logs on FortiGate. Based on the output shown in the exhibit, what can you say about the tunnels on this device?

The master tunnel HU82-VPN3 cannot accept ADVPN shortcuts.

The device steers voice traffic through the VPN tunnel HUB1-VPN3.

The VPN tunnel HUB1-VPN1_0 is a shortcut tunnel.

There is one shortcut tunnel built from master tunnel VPN4.

NEW QUESTION 38
Refer to the exhibits.

The exhibits show the configuration for SD-WAN performance. SD-WAN rule, the application IDs of Facebook and YouTube along with the firewall policy configuration and the underlay zone status.
Which two statements are true about the health and performance of SD-WAN members 3 and 4? (Choose two.)

Only related TCP traffic is used for performance measurement.

The performance is an average of the metrics measured for Facebook and YouTube traffic passing through the member.

Encrypted traffic is not used for the performance measurement.

FortiGate identifies the member as dead when there is no Facebook and YouTube traffic passing through the member.

NEW QUESTION 39
Refer to the exhibit.

An administrator is troubleshooting SD-WAN on FortiGate. A device behind branch1_fgt generates traffic to the 10.0.0.0/8 network.
The administrator expects the traffic to match SD-WAN rule ID 1 and be routed over HUB1-VPN1. However, the traffic is routed over HUB1-VPN3.
Based on the output shown in the exhibit, which two reasons, individually or together, could explain the observed behavior? (Choose two.)

HUB1-VPN3 has a higher member configuration priority than HUB1-VPN1.

The traffic matches a regular policy route configured with HUB1-VPN3 as the outgoing device

HUB1-VPN1 does not have a valid route to the destination

HUB1-VPN3 has a lower route priority value (higher priority) than HUB1-VPN1.

NEW QUESTION 40
Refer to the exhibit.

The exhibit shows the health-check configuration on a FortiGate device used as a spoke. You notice that the hub FortiGate doesn’t prioritize the traffic as expected.
Which two configuration elements should you check on the hub? (Choose two.)

The performance SLA has the parameter priority-out-sla configured.

This performance SLA uses the same members.

The performance SLA uses the same criteria.

The performance SLA is configured with set embedded-measure accept.

NEW QUESTION 41
Exhibit.

Two hub-and-spoke groups are connected through redundant site-to-site IPsec VPNs between Hub 1 and Hub
2
Which two configuration settings are required for the spoke A1 to establish an ADVPN shortcut with the spoke B2? (Choose two.)

On hubs, auto-discovery-forwarder must be enabled on the IPsec VPNs to hubs.

On hubs, auto-discovery-receiver must be enabled on the IPsec VPNs to spokes.

On hubs, auto-discovery-forwarder must be enabled on the IPsec VPNs to spokes.

On hubs, auto-diacovery-sender must be enabled on the IPsec VPNs to spokes

NEW QUESTION 42
What are three key routing principles of SD-WAN? (Choose three.)

Directly connected routes have precedence over SD-WAN rules.

Policy routes have precedence over SD-WAN rules.

SD-WAN rules are skipped if the best route to the destination is a static route

SD-WAN rules are skipped if the best route to the destination is not an SD-WAN member.

SD-WAN members are skipped if they do not have a valid route to the destination.

NEW QUESTION 43
You are planning a new SD-WAN deployment with the following criteria:
– Two regions
– Most of the traffic is expected to remain within its region
– No requirement for inter-region ADVPN
To remain within the recommended best practices, which routing protocol should you select for the overlays?

OSPF for the routing within each region and EBGP between the regions.

IBGP with BGP on loopback within each region and EBGP between the regions.

IBGP with BGP per overlays within each region and IBGP with BGP on loopback between the regions.

IBGP within each region and between the regions.

NEW QUESTION 44
Refer to the exhibit.

The exhibit shows the BGP configuration on the hub in a hub-and-spoke topology. The administrator wants BGP to advertise prefixes from spokes to other spokes over the IPsec overlays, including additional paths.
However, when looking at the spoke routing table, the administrator does not see the prefixes from other spokes and the additional paths Which three settings must the administrator configure inside each BGP neighbor group so spokes can learn the prefixes of other spokes and their additional paths? (Choose three.)

Set additional-path to send

Set additional-path to forward

Enable route-reflector-server

Enable route-reflector-client.

Set adv-additional-path to the number of additional paths to advertise.

NEW QUESTION 45
Refer to the exhibit. For your ZTP deployment, you review the CSV file shown in exhibit and note that it is missing important information. Which two elements must you change before you can import it into FortiManager? (Choose two.)

You must associate a device blueprint with each device

You must define a name for each device

You must define a value for each device and each metadata variable that defines an IP address.

You must define a value for each device and each user-defined metadata variable.

NEW QUESTION 46
Refer to the exhibit.An administrator checks the status of an SD-WAN topology using the FortiManager SD-WAN monitor menus. All members are configured with one or two SLAs. Which two conclusions can you draw from the output shown? (Choose two.)

The template view should be used to see the hub devices.

One member of branch2_fgt is missing the SLAs.

branch2_fgt establishes six tunnels to the hubs and they are all up.

This SD-WAN topology contains only two branch devices.

NEW QUESTION 47
Refer to the exhibits. An administrator is testing application steering in SD-WAN. Before generating test traffic, the administrator collected the information shown in the first exhibit. After generating GoToMeeting test traffic, the administrator examined the corresponding traffic log on FortiAnalyzer, which is shown in the second exhibit.
The administrator noticed that the traffic matched the implicit SD-WAN rule, but they expected the traffic to match rule ID 1.
Which two reasons explain why some log messages show that the traffic matched the implicit SD- WAN rule? (Choose two.)