Valid CCNP Security 300-730 Dumps Ensure Your Passing [Q50-Q68]

QUESTION 50
Which redundancy protocol must be implemented for IPsec stateless failover to work?

QUESTION 51
What are two purposes of the key server in Cisco IOS GETVPN? (Choose two.)

QUESTION 52
Refer to the exhibit.

Which type of Cisco VPN is shown for group Cisc012345678?

QUESTION 53
Refer to the exhibit.

The customer must launch Cisco AnyConnect in the RDP machine. Which IOS configuration accomplishes this task?

QUESTION 54
Which two are characteristics of GETVPN? (Choose two.)

QUESTION 55
What is a requirement for smart tunnels to function properly?

QUESTION 56
Which technology is used to send multicast traffic over a site-to-site VPN?

QUESTION 57
Refer to the exhibit.

Which type of Cisco VPN is shown for group Cisc012345678?

QUESTION 58
Which configuration sets up spoke-to-spoke dynamic tunnels of FlexVPN?

QUESTION 59
What is a requirement for smart tunnels to function properly?

QUESTION 60
Which feature allows a DMVPN Phase 3 spoke to switch to an alternate hub when the primary hub is unreachable?

QUESTION 61
Refer to the exhibit. Cisco AnyConnect must be set up on a router to allow users to access internal servers 192.168.0.10 and 192.168.0.11.
All other traffic should go out of the client’s local NIC.
Which command accomplishes this configuration?

QUESTION 62
Which two features provide headend resiliency for Cisco AnyConnect clients? (Choose two.)

QUESTION 63
Which redundancy protocol must be implemented for IPsec stateless failover to work?

QUESTION 64
Refer to the exhibit. The network security engineer identified that the hub router cannot send traffic to the spoke router. Based on the provided output, which action resolves the issue?

QUESTION 65
Which VPN solution uses TBAR?

QUESTION 66
Users cannot log in to a Cisco ASA using clientless SSLVPN. Troubleshooting reveals the error message “WebVPN session terminated: Client type not supported”. Which step does the administrator take to resolve this issue?

QUESTION 67
What must be configured in a FlexVPN deployment to allow for direct communication between spokes connected to different hubs?

QUESTION 68
An administrator is deciding which authentication protocol should be implemented for their upcoming Cisco AnyConnect deployment. A list of the security requirements from upper management are: the ability to force AnyConnect users to use complex passwords such as C1$c0451035084!, warn users a few days before their password expires, and allow users to change their password during a remote access session. Which authentication protocol must be used to meet these requirements?