2026 Updated Verified NACE-CIP1-001 dumps Q&As – Pass Guarantee or Full Refund [Q40-Q60]

QUESTION 40
According to SSPC PA 2 a Spot Measurement is:

QUESTION 41
If a Thermoset coating is heated it will:

QUESTION 42
You are the NACE Inspector on a job where the Owner’s specification requites you to perform a twice daily check of blast pressure at the nozzle. It is now day 30 on the job and all of your readings have been within compliance. The Contractor complains that these checks taking up much time and in view of the compliant results they are unnecessary.
Your FIRST preferred course of action is to:

QUESTION 43
Upon arrival of coating materials, the inspector should

QUESTION 44
When applying Thermal Spray Coatings the specification is most likely to refence:

QUESTION 45
Passivation can best be described as:

QUESTION 46
NACE No. 4/SSPC-SP-7 is a joint standard for

QUESTION 47
The Inspector’s Log Book is generally:

QUESTION 48
If a contractor is using a poorly maintained compressor to supply air for abrasive blast cleaning and conventional airspray, the coating inspector should perform a

QUESTION 49
You are asked to be the only coating inspector on a small bridge recoating job where existing coating contains lead. The owners’ representative has supplied you with the local code governing the removal and disposal of lead based coatings, however upon reading the document you having great deal of difficulty understanding the technical language.
As a NACE CIP Level 1 Inspector your preferred course of action is to:

QUESTION 50
Common errors that may produce inaccurate readings when using a Dial-Type Magnetic Pull-Off Dry Filth Thickness (DFT) gauge include:
Select All That Apply

QUESTION 51
Due to a previous premature coating failure the owner has required the original coating applicator to return to remove and replace 10,000 square feet of a failed three coat system at the applicator’s cost. Due to the financial implications of another failure, the owner has offered you the job as the NACE CIP Level 1 Coating Inspector and explained that he expects you to be his “insurance policy” for this job. You have never been involved in a warranty job before and are unfamiliar with the coating system.
Your preferred FIRST course of action is to:

QUESTION 52
The most important factor resulting in improved job site safety is:

QUESTION 53
Galvanic corrosion occurs on which of the following substrates:

QUESTION 54
ISO SA 2.5 is defined as:

QUESTION 55
Corrosion generally occurs at which of the following sites:

QUESTION 56
ISO SA 3 is directly equivalent to:

QUESTION 57
Excess moisture during holiday testing can cause erroneous indications by creating a path across the surface of the coating to pinholes previously detected, or directly to the signal return connection.
This is often referred to as:

QUESTION 58
You are the NACE Inspector on a 5000 sq. ft. job where SSPC PA 2 has been specified.
Assuming all areas are in compliance, how many gauge readings and spot measurements are required?

QUESTION 59
You ate the NACE Inspector on a job where NACE No. 2/SSPC – SP 10 has been specified. You are finding the Contractor is leaving mill scale on the on surface and as a result you have been rejecting the blast. The Contractor is very upset and has told you that the standard permits up to 5% of the mill scale to remain and still be in be in compliance with the standard.
Your FIRST preferred course of action is to:

QUESTION 60
Solvents are added to coating formulations to