[2022] HPE2-W09 Actual Exam Dumps, HPE2-W09 Practice Test [Q41-Q58]

Rate this post

[2022] HPE2-W09 Actual Exam Dumps, HPE2-W09 Practice Test

Real4exams HPE2-W09 dumps & HPE Product Certified sure practice dumps

HP HPE2-W09 Exam Syllabus Topics:

Topic Details
Topic 1
  • Describe the benefits of VSX for a data center networking environment and implement VSX
  • Understand, describe and configure Datacenter Bridging (DCB)
Topic 2
  • Understand how to use NetEdit to simplify ArubaOS-CX device configuration
  • Understand the components of the ArubaOS-CX Switching architecture
Topic 3
  • Describe data center network design principles, including data center deployment models and the impact of various data center technologies on design

 

NEW QUESTION 41
Refer to the exhibit.

Switch-1 and Switch-2 ate ArubaOS-CX switches that implement VXLAN WITHOUT Ethernet VPN (EVPN). Switch-2 uses the same VNI-to-VLAN mappings as Switch-1. Is this how the specified servers communicate?
Solution: The first time that Server I communicates with Server 3, It sends an ARP request to resolve Server 3’s MAC address.

 
 

NEW QUESTION 42
Can you attach this type of ArubaOS-CX interface to a VRF?
Solution: A loopback interface

 
 

NEW QUESTION 43
A customer’s servers use ISCSI, and they send data and storage traffic on the same pair of I OGbE links. Is this a best practice for supporting the ISCSI requirements?
Solution: Set up dedicated switches to connect to iSCSl arrays. Connect top of rack (ToR) switches, which will support both data and storage traffic, to those dedicated switches.

 
 

NEW QUESTION 44
An ArubaOS-CX is ssmq DCBX on Interface 1/1/1. You enter this command:
show dcbx interface 1/1/1
Is this where you can see whether the connected converged network adapter (CNA) has accepted the application priorities advertised with DCBX?
Solution: in the Enhanced Transmission Selection (ETS) Local advertisement section

 
 

NEW QUESTION 45
You ate using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard conflg to the switches, but need the config to include a few device-specific settings such as hostname and IP address.
Is this what you should do?
Solution: Instead of using a standard configuration plan to deploy the configuration, create an auto config plan that uses scripts.

 
 

NEW QUESTION 46
Refer to the exhibit.

Switch-1, Switch-2, and the router run OSPF on LAG 100, which is a Layer 3 LAG. Does this correctly explain how to control how core-to-access traffic Is forwarded?
Solution: To reduce the amount of traffic sent over the ISL between Switch-1 and Switch-2. enable Equal Cost Multi Path (ECMP) on both Switch-1 and Switch-2.

 
 

NEW QUESTION 47
Refer to the exhibit.

Switch-1, Switch-2, and the router run OSPF on LAG 100, which is a Layer 3 LAG. Does this correctly explain how to control how core-to-access traffic Is forwarded?
Solution: To reduce the amount of traffic sent over the ISI between Switch-1 and Swltch-2. enable active forwarding on LAG 100 on both Switch-1 and Switch-2.

 
 

NEW QUESTION 48
Is this a rule for configuring schedule profiles on an ArubaOS-CX switch?
Solution: With the exception of a single strict priority queue, all queues must use the same scheduling algorithm.

 
 

NEW QUESTION 49
You are using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard config to the switches, but need the config to include a few device-specific settings such as hostname and IP address.
Is this what you should do?
Solution: omit the device-specific settings from the configuration plan and include them in command scripts instead.

 
 

NEW QUESTION 50
Is this a difference between a typical data center network’s requirements and a typical campus network’s requirements?
Solution: Data center networks are typically less oversubscribed than campus networks.

 
 

NEW QUESTION 51
You plan to use multi-protocol BGP to implement dynamic VRF route leaking on an ArubaOS-CX switch.
Is this a rule for the setup?
Solution: You cannot leak multicast routes.

 
 

NEW QUESTION 52
Is this a use case for disabling split-recovery mode on ArubaOS-CX switches in a Virtual Switching Extension (VSX) fabric?
Solution: You are not concerned about split Drain Issues in your environment, so you want the secondary member to keep its links up if the ISL falls.

 
 

NEW QUESTION 53
Is this part of the process for using NetEdit to update firmware on ArubaOS-CX switches?
Solution: Use a firmware update plan to manage both updating the Image on selected devices and reboot.

 
 

NEW QUESTION 54
Is this part of a valid strategy for load sharing traffic across the links in an Ethernet Ring Protection Switching IERPS) solution?
Solution: Implement Virtual Switching Extension (VSX) on pairs of ERPS switches at the same site.

 
 

NEW QUESTION 55
Does this correctly describe NetEdit’s notification capabilities?
Solution: NetEdlt can send an error link to admins through ServlceNow.

 
 

NEW QUESTION 56
Does this correctly describe Network Analytics Engine (NAE) limitations on ArubaOS-CX switches?
Solution: Different switches have different limitations for the number of NAE scripts, monitors, and agents supported.

 
 

NEW QUESTION 57
Your task is to configure an EVPN solution for a dual-stack IPv4 and IPv6 protocol in the overlay networks. Is this statement about EVPN and IPv6 correct?
Solution: The IPv6 and IPv4 overlay networks can be encapsulated with VXLAN and transmitted through the underlay network.

 
 

NEW QUESTION 58
Is this a use case for deploying Ethernet Ring Protection Switching (ERPS)?
Solution: extending Layer 2 communications between data centers that connect over Layer 3 MPLS links

 
 

HPE2-W09 Actual Questions and Braindumps: https://www.real4exams.com/HPE2-W09_braindumps.html

         

Related Links: courses.digitalrakshith.com mednerd.in z-edike.com lms.drektashow.com academy.sirsardarkhan.com www.atalphatrader.com

Leave a Reply

Your email address will not be published. Required fields are marked *

Enter the text from the image below